Comments on: Burton CO2 Snowboard Bindings

By: skaterg1001

skaterg1001 — Sat, 03 Oct 2009 16:58:06 +0000

ok thinking about …
ok thinking about getting some 09 burton mission bindings and a ride board and iam not to sheer if they can mount on to it so plz tell me if u know

By: Shizock

Shizock — Sat, 03 Oct 2009 16:58:06 +0000

i went triad (WHT) …
i went triad (WHT) and i got them for about 150 and love them. Also im 6′6 and 200+.

By: DStat19

DStat19 — Sat, 03 Oct 2009 16:58:06 +0000

holy bro thats …
holy bro thats big. how tall are you. id go triad. way cheaper and gets the job done just as well

By: Shizock

Shizock — Sat, 03 Oct 2009 16:58:06 +0000

i just got a custom …
i just got a custom ics 167w. im torn between the co2 and the triads. does anyone have any suggestions?

By: AdamScadAdam

AdamScadAdam — Sat, 03 Oct 2009 16:58:06 +0000

or just adjust them.
or just adjust them.

By: MadsJuster

MadsJuster — Sat, 03 Oct 2009 16:58:06 +0000

Have those too, …
Have those too, they’re awesome

By: DiMeThIcOnE

DiMeThIcOnE — Sat, 03 Oct 2009 16:58:06 +0000

Agreed 100% …
Agreed 100% UCSDEngineerDoctor! Burton blows their boards fall apart after a few good sessions and their bindings are all the same with different names and higher prices and ridiculas forward lean.

By: DEditor51

DEditor51 — Sat, 03 Oct 2009 16:58:06 +0000

Sick bindings just …
Sick bindings just got em

By: UCSDEngineerDoctor

UCSDEngineerDoctor — Sat, 03 Oct 2009 16:58:06 +0000

Burton bindings esp …
Burton bindings esp. their C60/CO2’s have too much forward lean. This forward lean causes pressure points all over your calves. And even worst due to the excessive forward lean; there is a big gap between the heel of your boot and the binding’s heelcup/highback causing major heel left on toe side turns! Also Burton’s carbon fiber highback looks very flimsy thin and they skimp out on carbon since it is so expensive and .: had to reinforce it with the cheap plastic.

By: thehouseboardshop

thehouseboardshop — Sat, 03 Oct 2009 16:58:06 +0000

thanks for the …
thanks for the recommendation – I’ll check it out